TOP2000B Banner welding machine
Product parameters:
Power:1800W
Fan:Leister original fan
Walk speed:1-12m/min
laser:laser positioning
line,make welding more accurate
Handrial:standing to
operate,move machine conveniently
LED light:more convenient work
in night
Temperature control:digital
temperture control,diginal display,temperature float±1℃
Heating element:Top2000B is
original Leister heat gun
Motor:30w
Voltage:220V/230V
Frequency:50/60HZ
Temperature scope:30-650 ℃
The thickness of material to be
weld:0.2-2mm.
Welding width:2-5cm
Net weight:16kg
Gross Weight:22kg
Packing size:56*39*39mm
Package:
Carton & Wooden.
1. Operation:
1.First, make the picture smooth and tight, take joiner to accurate (about 2-4cm), fixed edges with tape or glue on
the ground.
2.Set temperature and walk speed:connect power, set temperature and walk speed(according to thickness of banner), warm the welder.(in general temperature we set is 350-400 degree it means put set temperature button of the heat gun around 8.Walking speed is around 4,
if the banner burnt.we can put temperature lower or make walking speed faster. If can not weld strong,
put temperature higher or make walking speed slower).check photo below:
3.Start welding:when actual temperature of the display screen reaches temperature that you want, we can begin to weld.put the walking handrail(at end of the machine)to left,machine Begin to work automatically.
At begin of weld,we should use one hand to take one banner up,then put nozzle between two banners
4.During welding,let hot air nozzle between two overlap pieces. And be make sure hot air nozzle and Rubber wheel walk in straight line.if not,please adjust by hand.check photo:
5.Finish welding:turn the walking handrail to the right ,machine stop walk,but before cut off the power,we should put the set temperature button to zero.when the actual temperature below 50 degree.we can cut off the main power.or it would damage heat system.
Tips:For first user,we can use waste banner to test and find proper temperature,we can do like this:take a small banner close the nozzle,if the banner hot melt quickly,it means,the temperature is OK,it not strong or burnt,we can increase or reduce temperature.we can also write down the temperature for this thickness of banner as sample.in next welding,based on this temperature.we just need
to increase or reduce the temperature depends on thickness of banners.
. notice:
1. During operating, if the surface cloth is dissolved and scorched or the cloth are not sticked together, please stop to adjust the temperature or speed.
2. During operating,if the seaming part is not in right position, please stop to adjust fixing position.
3. During operating, make sure clothes are flat so that stick together smoothly.
4. The hot wind of heater cannot touch the press-wheel or the rubber of press-wheel is easy to be burned down.
5.Adjust temperature to zero before turn off the heater.Switch off after 5-10 minutes.